Showing 6–10 of 16 results
Showing 6–10 of 16 results
-
Belgotch Type 34 Standard Model
The roller does not roll in the belt surface, and the conveyor is suitable for carrying items that get dirty easily. The upper part drive type should be used when there is a small amount of water or oil.
-
Belgotch Type 34 Joint Model
The meander-less model of the joint model TYPE 34-J1. It supports severe conditions such as forward and reverse operations and installation to places where it is difficult to perform maintenance inspection.
-
Belgotch Type 34 Joint Model
Dimension R at both ends of the conveyor is 8 mm, and the model allows smooth transfer. A meander-less belt is adopted for the roller edge. Stable conveyance with less deviation is realized. Use the conveyor for items with a length of 40 mm or more. Entrance, exit, and one-side conveyors can also be made.
-
Belgotch Type 34 Knife Edge Model
Dimension R at both ends of the conveyor is 8 mm, and the model allows smooth transfer. A meander-less belt is adopted for the roller edge. Stable conveyance with less deviation is realized. Use the conveyor for items with a length of 40 mm or more. Entrance, exit, and one-side conveyors can also be made.
-
Belgotch Type 34 Roller Edge Meander less Model
The belt surface is troughed at the center, and this allows carrying small things and particulate works that are likely to be spilled without fail. The right and left belt support plates can easily be removed for cleaning etc.